What are the precautions for using welding equipment ?

1. Check the resonance frequency of the fixture after the automatic resonance is turned on every day, if the frequency resonance error is abnormal, AMP overload and other alarms, please check whether the screws on the fixture have been loosened. (If you need our technical support, you need to check the fault display code of the vibration controller in the box. 2. If there are outdated and initial alarms during automatic operation, check that the soundproof door is not completely closed or the table is not completely down in the state that you have pressed the startup switch, make sure that the table down knob is not red on the manual operation screen, check the hydraulic system, and the hydraulic gauge should show more than 50kgf/sq-cm to check whether there are any interfering obstacles, soundproof door, or the table is not completely down, and check that there is no interference obstacles. Check whether there is any interference obstacle, whether the sound insulation door limit indication and air pressure are normal.

3. After the power is turned off, at least one minute interval before restarting. 4. Replace the hydraulic system filter alarm, hydraulic system filter is too dirty to clean or replace. 5. Hydraulic pump motor overload and overcurrent, check the hydraulic solenoid valve, check the hydraulic motor, check the surface temperature of the hydraulic motor (more than 60 ° C, if there is a problem). Check the reset of the thermal relay and the current value.

6. Do not put your hand near the vibrating part. Do not put your hand under the vibrating part when the equipment is working. 7. Cut off the power supply when the equipment is being repaired.

8. When moving or installing the vibration friction welding machine, pay attention to the position, level, input power, input air (air pressure) and other matters.

9. Grounding should be thorough, the ground wire should be connected to the designated terminal, more than 3 kinds of grounding methods. Wiring and inspection should be performed by a skilled electrician.